PERFORMER-PLUS CAMSHAFT KIT FOR SMALL-BLOCK FORD 351W V8.

Brand New Edelbrock Performer-Plus camshaft for Small-Block Ford 351W V-8 (Part #2182).

Edelbrock part #2182 Performer-Plus camshaft is designed for small-block Ford 351W V-8 applications. This Edelbrock cam kit produced 325 ft-lbs. of torque when used with #2181 intake and stock iron cylinder heads on a 351W engine. The camshaft will produce optimum torque from the low-end to the mid-range, Performer-Plus camshafts match with Performer manifolds for vehicles operating from off-idle to 5500 rpm. This Performer-Plus is a smooth idling cam for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. All camshafts include flat tappet lifters, assembly lube and instructions. 

Installation Notes:

• Recommended Valve Springs for OEM heads: Edelbrock part #5822 non-rotator/# 5922 Rotator
• Not for 1985 and later engines with roller lifters.
• In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.
• Oil/additive must contain Zinc designed for use with flat tappet camshafts.
• Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
• Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.

Specs:

• Series: Performer-Plus
  
• Grade Type: Performance
  
• Lifter Materials: Hardened Steel
  
• Computer Controlled Compatible: No
  
• Lifter Type: Hydraulic
• Duration @ .050 Intake: 204 degrees
• Duration @ .050 Exhaust: 214 degrees
• Lift @ Valve Intake: .448"
• Lift @ Valve Exhaust: .472"
• Lobe Separation: 112 Degrees
• Intake Centerline: 107 Degrees
• Idle Vacuum @ 1000 RPM's: 15"

You can view and download the complete assembly instruction booklet here.